Page 3
Fig. 1
Fig. 2
Fig. 3
Fig. 5
Fig. 6 Turn 90°
Fig. 7
Turn back 90°
Fig. 4
3. lnsert the Front Fork (F) into the Vehicle
Body (A), see Fig.2.
2. Take the Vehicle Body (A), see Fig.1.
7. Turn 90 clockwise afterward to original
position, see fig.7. To secure the Front (F)
and the Handlebar (B) together, use the
large M19 Nut (H) on the part of the
handlebar (B) that protrudes out from the
Front Fork (F), see the line drawing next
to Fig.7.
NOTE:
- Ensure of 'V' arrow on the stem points
towards the rear of the vehicle body.
4. lnsert the Handle bar (B), part way into the
head of the Vehicle Body (A) and into the
Front Fork (F), see Fig.3.
5. Take the two wires protruding from the
Vehicle Body (A) and feed them through the
oval hole in the handlebar plate, see Fig.4.
Connect these wires to the pre-fitted wires
on the Handlebar (B), see Fig.5.
6. lnsert the Handlebar (B)When the handle
bar cannot into the Vehicle Body. (A)Pass
through, turn 90 anti-clockwise and push
to the lowest position, see Fig.6.
(9)Thread front fork though the hole
of front mudguard as the figure
shown and screw it with nut M19.
Handlebar
Front fork
(8)Thread handlebar through
the hole of front fork as the
figure shown.
Front fork
Front
mudguard
Nut M19
