1.Suitable for children aged between 3-7
years old
2.Maximum weight for user 30KG
3.Only one child to use the vehicle at
one time
4.Children must be supervised by an adult
at all time when using the vehicle.
5.Protect vehicle from rain,splashes of
water and damp
6.DO NOT operate vehicle on wet,sandy,
muddy, grass or uneven ground.
SAFETY WARNING:
-Operating temperature: 0
℃
- 40
℃
-Dimension:810L x 420W x 575H (mm)
-Speed of vehicle:2.5km/h
-Charging time: 12-16 hours. not over 20
hours for each time
-Battery life: approx 300 charges
-Battery type: 6V 4Ah sealed lead- acid
-Charge only with charger supplied otherwise
damage may occur.
-Fuse type: 15A glass fuse
SPECIFICATION:
A- Main body
B- Front body fairing(x1)
C- Handle Bar Assembly (x 1)
D- Plastic dash board (x1)
E- Head set bolt (x1)
F- Head set nut (x1)
G- Front Mudguard (x1)
H- Fork disc cover (x2)
l- Front wheel (x1)
J- Front Wheel trims (x 2)
K- Front wheel Axle (x1)
L- Nylon nuts for axle(x2)
M- Axle Washers (x2)
N- Front fairing screws(pt) (x3)
0- Dash board screw(tt) (x1)
PART:
1. Remove all parts from the box and check quantity and description against part list
2. Using fairing screws, screw fairing to the handle bar assembly.(through flat metal plate).
3. Slide handle bar assembly over the body of the toys.
4. Place plastic dash board on top of handle bar assembly and roughly fix with the screw (0).
5. Push headset bolt (E) through handle bar assembly.(see fig 1)
6. Place plastic mudguard between handle bar assembly and locate the protruding thread of
the 'Head set bolt' (E).(see fig 2)
7. Screw up the Head set nut on to the head set bolt thread and tighten with spanner provided.
8. Slide up fork/disc cover inside the mudguards and line up with the holes in the metal forks
(these are secured to the handle bar assembly).(see fig 3)
9. Once all wheel assembly aligned (see fig 4), push the wheel axle(K) through the fork and
wheel assembly until thread is visible both sides.(fig 5)
10. Add a washer and Nylon nut to both sides and tighten using spanner.(do not over tighten
as wheel will not run freely)
ASSEMBLY:
Page 1