Townlabs TL518, Инструкция по эксплуатации

Страница: 18 / 24

18
Spindle Speed Control
Periodic maintenance.
•
Do not over tight gib screws on dovetail axes. Gibs are metal strips that sit on one side of a
dovetail slide, such as the cross-slide and compound, and which are adjustable to take up any slack
or slop so that the dovetail slide is very smooth. The table should move smooth by hand cranks.
All dovetails are hand lapped. However as any mechanical equipment the mill requires some
running time to make the matching parts fit. After 10-20 hours of operation it may be necessary to
adjust gib screws on all axes.
The fuse is located in the bottom portion of the power
entry on the back of the controller. Use a small
screwdriver to pull open the fuse compartment.
The fuse is 5mm size and rated 10 amps.
Spindle speed control adjustment is located on the right
side of the spindle carrier. The front switch central
position turns spindle off. In VAR-position spindle
RPM is adjustable. In FULL-position spindle turns at
full speed regardless of the know position. The spindle
RPM scale is not calibrated. It is ratiometric to the
maximum speed.