1. Remove the side panel retainers located on the underside of the fi rebox heat
shield. The retainers are each held in place by one screw.(Fig. #42)
2. Insert the back panel into the fi rebox by tilting the panel and rest the panel on
the seat tabs at the back of the fi rebox. (Fig. #38&39)
NOTE: Centering tabs on the panel should be located inside the slots in the
support tabs..
3. While supporting the back panel insert the left side panel into the fi rebox. Posi-
tion the top of the panel against the side of the unit. (Fig. #39)
4. Reinstall left side retainer.
NOTE: Notch at bottom of side panel faces to front of unit.
NOTE: Install burner now.
5. Install the Right side panel in the same manners as the Left side being sure
to tuck the lighting wires into the space in the rear corner.
6. Reinstall the Right side panel retainer.(Fig.#42)
7.
Place the front panel on the front lip of the fi rebox, wide fl ange facing the
center of the fi replace. (Fig. #40a & #40b)
WIDE EDGE TO CENTER OF
FIREPLACE
Fig #40b
FRONT PANEL
Fig. #39
Fig. #38
Fig. #40a
SUPPORT TABS
27
TCWS.38CE3 011012-44
Firebox Panels Installation
