7
TC36_NG02DN 020317-16
5056.42702D
Ember Material Placement
A large bag of ember material is shipped with the fireplace and needs to be installed to ensure opti-
mum performance and flame appearance.
Pull apart the material into ember size pieces (approximately 1” squares) and gently place them into
the burner pan. Do not compress, leave it loose for best performance.
Fill the burner pan level with the top of the pan at rear, and gradually slope forward to the firebox
floor at the front, covering both burner tubes.
Place remaining ember material outside of the burner pan as desired to cover-up gas lines and
brackets.
Note: Ember material placement and amount will affect flame appearance. More ember material
results in lower flame height. Add or remove as needed until desired flame affect.
Glowing ember material
Figure 11: Glowing ember placement.
