311008-2 EUROPEAN COPPER DECORATIVE CAP 5056.425212
TC TERMINATION CAP
TC VENT PIPE
NON-COMBUSTIBLE
CHASE TOP
*
Fig #5
Installation
1. Install the vent system as per instal-
lation instructions supplied with the Town
and Country fireplace. The vent pipe must
extend the specific height above the chase
top as shown in the table. If it extends high-
er, the decorative cap will not fit over-top of
the terminal, and if shorter, the fireplace will
not operate safely. Place an appropriately
sized flashing and storm collar over the vent
pipe and seal. Ensure the flashing size will
not impede the installation of the decorative
shroud.
2. Remove weather shield/rain cap from
chimney pot base if attached. Save screws
for later re-attachment. (Fig #6)
3. Attach all 8 mounting brackets to chim-
ney pot base with carriage bolts, washers, &
lock nuts.
Position chimney pot over vent, make sure
pot is centered. Level chimney pot by adjust-
ing brackets as necessary. When chimney
pot is level, tighten nuts to secure brackets
in place. Mark bracket hole locations on
chase top. Remove chimney pot and drill
holes in marked locations. Set flashing gas-
kets over each drilled hole with vinyl side
up. Set chimney pot in place with brackets
on gaskets. Anchor pot to chimney top with
correct fasteners. Tighten each fastener se-
curely. Caulk all fasteners connecting the
chimney pot to the top of the chimney.
4. Lower the Town and Country roof vent
termination cap over the vent pipe and se-
cure in place with screws provided. Seal
the screw heads and joint with caulking to
prevent any moisture entering the vent sys-
tems.
5. Lower weather shield/rain cap over
the Town and Country Termination Cap and
attach to chimney pot base with screws pre-
viously removed.
Model
Dimensions
above chase top
King-TC
39 "
Pawn-TC
17"
Bishop l-TC
40
1/2
"
Bishop ll-TC
27
1/8
"
(See dimensions
in table below)
*
(KING-TC Shown)
WEATHER SHIELD/RAIN CAP
CHIMNEY POT BASE
MOUNTING BRACKETS
Fig #6
NOTE:
The mounting brackets are
designed to allow for drainage.
DO NOT add grout or sealant around
the base of the chimney pot.
