5
This appliance must be earthed. In the event of an electrical
short circuit, earthing reduces the risk of electric shock by
providing an escape wire for the electric current. This
appliance is equipped with a cord having an earthing wire
with an earthing plug. The plug must be plugged into an
outlet that is properly installed and earthed.
WARNING :
Improper use of the earthing plug can result
in a risk of electric shock. Consult a qualified electrician or
serviceman if the earthing instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly earthed. If it is necesary to use an extension cord,
use only a 3-wire extension cord that has a 3-blade earthing
plug, and a 3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord should be
equal to or greater than the electrical rating of the appliance.
IMPORTANT
The wires in this mains lead fitted to this appliance are
coloured in accordance with the following code.
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows : the wire
which is coloured green-and-yellow must be connected to
the terminal in the plug which is marked with the letter ‘E’ or
by the earth symbol or green-and-yellow. The wire which is
coloured blue must be connected to the terminal which is
marked with the letter ‘N’ or coloured black. The wire which
is coloured brown must be connected to the terminal which
is marked with the letter ‘L’ or coloured red.
WARNING :
The appliance must be earthed.
1. Ventilation
Do not block air vents. If they are blocked during
operation, the oven may overheat and eventually cause a
failure. For proper ventilation, allow more than 76mm of
space between oven sides and the rear minimum height
of free space necesary above the top surface of the oven is
100mm.
2. Steady, flat location
This oven should be set on a steady, flat surface. This oven
is designed for counter top use only.
The microwave oven shall not be placed in a cabinet
unless it has been tested in a cabinet.
3. Leave space behind and side
All air vents should be kept a clear. If all vents are covered
during operation, the oven may overheat and, eventually,
fail.
4. Away from radio and TV sets
Poor television reception and radio interference may
result if the oven is located close to a TV, Radio antenna,
feeder and so on. Position the oven as far from them as
possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or water splashes
when choosing a place to position it, or the insulation
might be adversely affected and breakdowns occur.
6. Power supply
• Check your local power source. This oven requires a
current of approximately 5.0 amperes, 220-240V 50Hz.
• The power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on this
oven. Using a higher voltage may result in a fire or
other accident causing oven damage. Using low voltage
will cause slow cooking. We are not responsible for
damage resulting from use of this oven with a voltage
of ampere fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
7. Examine the oven after unpacking for any damage
such as:
A misaligned door, Broken door, A dent in cavity. If any of
the above are visible, DO NOT INSTALL, and notify your
dealer immediately.
8. Do not operate the oven if it is colder than room
temperature.
(This may occur during delivery in cold weather.) Allow
the oven to become room temperature before operating.
EARTHING INSTRUCTIONS
INSTALLATION
RKW(TOWER)_QT1T(KOR-4A071S)_A5(�).indd 5
2020-07-17 �� 5:28:54
