Advanced Setting 1: Power Set
The “Power Set” setting can be used to adjust the number of pedal assist levels. The
recommended setting is the default on all Tower eBikes (0-5). This setting features 6 levels,
with Level 0 being no pedal assist and Level 5 being the highest pedal assist ratio (96%).
To change the number of assistance levels, select “Power Set” and then press
UP
or
DOWN
to select the pedal assist level range.
To store the changed setting and access the PAS ratio settings page, press
MODE
.
Press the
UP
or
DOWN
button to increase or decrease the pedal assist percentage for
each level. Note that this system supports up to 9 levels.
After the desired PAS ratio for each power level is inputed, press the
MODE
button to
confirm and return to the advanced settings interface.
Please see
Figure 4
at the end of this manual for available pedal assist level ranges
Advanced Setting 2: Current Setting
The current setting is pre-set to the correct value for this eBike (20A). This cannot be adjusted.
Advanced Setting 3: Assistance Number
The current setting is pre-set to the correct value for this eBike (n-12). This cannot be adjusted.
Advanced Setting 4: Speed Sensor
The current setting is pre-set to the correct value for this eBike (n-01). This cannot be adjusted.
Advanced Setting 5: Slow Start Up
The “Slow Start” feature can be used to delay the pedal assist power. For example, a 3 sec
delay will result in the pedal assist system kicking in 3 seconds after the rider begins to pedal.
The default value is 0 and the delay can be increased up to 3 seconds.
To change the slow start up settings, press the
UP
or
DOWN
button to adjust the value.
Press the
MODE
button to save the selection and return to the advanced settings page.
7
