TOUGH-WORKS MM493B, Инструкция по эксплуатации

Страница: 4 / 20

4
SAFETY GUIDELINES
the tool is in the “OFF" position before plugging
in.
• Know your tool. Learn the tool’s operation,
application and specific limitations before
using it.
• Sander MUST be used with Dust Collector to
capture dust.
• Disconnect tool when changing belt or abrasive
disc.
• Do not force tool. It will work most efficiently at
the rate for which it was designed.
• Keep hands away from moving parts and sanding
surfaces.
• Never leave tool running unattended. Turn the
power off and do not leave tool until it comes
to a complete stop.
• Do not overreach. Keep proper footing and
balance.
• Never stand on tool. Serious injury could occur
if tool is tipped or if belt or disc are unintenti-
onally contacted.
• Know your tool. Learn the tool’s operation,
application and specific limitations.
• Use recommended accessories (refer to page 13).
Use of improper accessories may cause risk of
injury to persons.
• Handle the workpiece correctly. Protect hands
from possible injury.
• Turn machine off if it jams. Belt jams when it
digs too deeply into workpiece. (Motor force keeps
it stuck in the work.)
• Support workpiece with miter gauge, belt platen
or work table.
• Maintain 1/16 ″ maximum clearance between
table and sanding belt or disc.
Think safety! Safety is a combination of operator
common sense and alertness at all times when
tool is being used.
Do not attempt to operate tool until it is completely
assembled according to the instructions.
CAUTION
MM493B