Installing the eyebolts
To install the eyebolts, do the following:
1.
Remove the M10 screws from the suspension points.
2.
Replace the M10 screw with the fender washer and eyebolts.
Notice!
If the eyebolts are removed reinstall the screws.
If the screws are not reinstalled air leaks occur in the enclosure, resulting in undesirable
performance.
!
Warning!
Eyebolts must be fully seated and oriented in the plane of pull. Always use fender washers at
least 1.5 inch in diameter and 1/16 inch thick under the eyebolt to distribute the load on the
enclosure.
No
Washer
Used
Washer
Used
Figure 4.8: Eyebolt shown with and without washer
en
21
Electro-Voice
User Manual
2016.04 | 05 | F.01U.276.083
