38
39
What to Do?
If you cannot operate with the remote control
The batteries may have worn out.
Replace the batteries.
■
Replacing the batteries
1
Unplug the power plug.
Switch the breaker on the distribution board to OFF.
(Electrical box type, Concealed power connection type)
The POWER LED goes off.
2
Remove the remote control from the hanger.
(Page14)
3
Open the battery cover and replace the
AA batteries.
(Page14)
Lit
4
Mount the remote control in the hanger.
5
Insert the power plug.
Switch the breaker on the distribution board
to ON.
(Electrical box type, Concealed power connection type)
The POWER LED lights up.
Freeze damage prevention
(continued)
2
Drain the pipe.
(1) Extend the wand.
Operate with the buttons on the back
side of the remote control.
1. Press [MENU].
2. Use
to select "CLEANING".
Press [ENTER].
3. Use
to select "WAND
CLEANING MODE ON/OFF".
Press [ENTER] to extend the wand
and then press [ENTER] again
to retract the wand. (Release the
pressure from the water supply pipe.)
Water comes out from around the wand.
(2) Unplug the power plug.
Switch the breaker on the distribution
board to OFF. (Electrical box type,
Concealed power connection type)
(3) Remove the cover and water
fi
lter drain valve.
Cover
Flat-head screwdriver
Water
fi
lter drain
valve
(4) Drain the water from the water supply hose.
(Expect Concealed power connection type)
Water supply hose
Horizontally
(5) After draining the water, install the
water
fi
lter drain valve and cover.
Insert the water
fi
lter drain valve and use a
fl
at-head screwdriver to tighten it securely.
(6) Insert the power plug.
Switch the breaker on the distribution
board to ON. (Electrical box type,
Concealed power connection type)
3
Check that the POWER LED on
the main display is lit up.
(Page 15)
4
Set the water and toilet seat
temperature to "High".
(Page 22)
(To maintain the temperature.)
When
fi
nished, close the toilet seat and toilet lid.
■
To use the Washlet again
The water needs to be resupplied. (See below)
When the ambient temperature is likely to drop to 0°C or lower, take measures to prevent
freezing.
Attention!
●
When the ambient temperature is likely to drop to 0°C or lower, do not use the energy saver feature.
(May damage the product.)
●
Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below 0°C.
Freeze damage prevention
Freeze Damage Prevention
Resupplying the Water
(After draining)
1
Open the shutoff valve.
• Check that water is not leaking from a pipe or the main unit.
2
If the power is not turned ON
Insert the power plug.
Switch the breaker on the distribution board to ON.
(Electrical box type, Concealed power connection type)
3
Discharge water from the wand.
(1) Pressing down the right side of the toilet seat,
(2) Press [REAR] on the remote control to discharge water from the wand for about two minutes.
(It takes about one minute maximum before water comes out. Catch the water in a paper cup or other receptacle.)
■
If the remaining water has frozen and no water comes out
•Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth soaked in warm water.
Soft cloth soaked in water
(to prevent scratching)
Paper cup
■
How to drain the water
1
Close the shutoff valve.
The water supply stops.
Do not remove the water
fi
lter drain
valve while the shutoff valve is open.
(Otherwise, water may leak out)
CAUTION
Reference
