Important Safeguards
(For your safety, please follow the instructions below.)
Read these Important Safeguards instruction thoroughly before using your product
and follow the precaution instructions carefully.
In this Instruction manual, the following symbols are shown for safe and proper
use of your product and in order to alert you to the possibility of personal injury and
damage to your property. The symbols and their meanings are as follows
Problem
Cause
Solutions
Leak
The cartridge is damaged
Disassemble the handle and cartridge to clean. If
cartridge is cracked, replece a new cartridge in the
same position
Leaks at lock nut
The lock nut is untightened
or the packing is out ordwr.
Tighten the lock nut by wrench or check the
packing. If the packing is out of order,
disassemble and change the new packing, then
reassemble and tighten it.
Installation
Care and maintenance
1. Do not use toilet cleaners with acid and base content for cleaning.
2. Do not use hard brush or steel wool for cleaning. Soft cloth or sponge is recommended to
prevent scratch marks.
3. Special metal/chromium cleaning cream is recommended.
4. When tools are required to grip. Use thick cloth to prevent scratch marks.
Troubleshooting
For more information
Please contact, Tel. 0-2117-9520, 0-2026-3561
TOTO (THAILAND) CO. LTD 77 Moo 5, Nong Plamor, Nong Khae, Saraburi 18140
Mount connectors parallel with the wall
Sealed
Tape
Leg
Do not piping hot water alternate with cold water.
Do not strike violently.
lf it is damaged, property damage, scalding and injuries are likely to
occur due to water leakage.
Prohibited
Do not allow children to use the product unattended.
Scalding or other injuries may occur.
Before installation, clean out dirt or other impurities which may have
collected in water pipes by allowing water to flow freely for a moment.
Mandatory
Use for tap water only.
Warning
Lock nut
Screw
Strainer
Lever handle
Cartridge
Leg
Cover
Body
Index
11
33
22
3
2
Inlet pipe
hot water
Inlet pipe
hot water
Inlet pipe
cold water
Inlet pipe
cold water
Working recommendation
1. Make sure that equipment and tools are in proper working condition.
2. Water pressure should be between 0.05-0.75 MPa.( 0.5-7.5 Kgf/cm
2
)
1. Make sure that equipment and tools are in proper working condition.
2. Water pressure should be between 0.05-0.75 MPa.( 0.5-7.5 Kgf/cm
2
)
Cover
Body
Strainer
Cover
"REI - S" SINGLE LEVER SHOWER TTMR304K
"REI - S" SINGLE LEVER SHOWER TTMR304K
"REI - S" SINGLE LEVER SHOWER TTMR304K
"REI - S" SINGLE LEVER SHOWER TTMR304K
210314
0M084
210314
0M084
150±8
150±8
