Installation Procedure
STEP
1
-
STEP
3-A
10
8
Fasten the spout with tool
(Royhan™ only)
Not included
1
Water supply
pipe
7
Attach the connector
to the controller
3
Mount the two water inlet
brackets on the wall
4
Connect the controller
to the water inlet brackets
2
Remove the controller cover
9
Attach the controller cover
5
Cut the spout
connecting hose
if necessary
6
Connect the spout
connecting hose
to the controller
STEP
1
Water supply pipe
Before installing the faucet, be sure to thoroughly flush away any foreign matter
such as dirt and sand trapped in the water supply pipe.
STEP
2
Remove the controller cover
Loosen the two screws on the front
cover.
Remove the controller cover
to the direction as shown in the figure.
controller cover
screws
Pull
STEP
3-A
Mount the two water inlet brackets on the wall
Mount the water inlet brackets on the
wall and temporarily tighten the screws.
The distance between the water inlet
brackets shall be 3-3/4"( 95mm ).
The controller and the two brackets
should be temporarily connected first
in order to affix.
To be continued on the back
Be sure to mount each water
inlet bracket in the correct
direction.
Otherwise, the strainer on the
water inlet bracket will be
inaccessible for cleaning.
Caution
Wall anchors
(not included)
Water inlet
bracket
Self tapping
screw
COLD IN
OUT
HOT IN
OUT
3-3/4"
(95mm)
Note: It is required to keep a distance
of 3-3/4" between the two water
inlet brackets.
This distance is fixed because
the controller attaches to these
brackets.
Make sure that the controller can be
attached to the water inlet brackets.
Tighten the water inlet brackets with
the eight self tapping screws.
Note: Anchors for the wall may be needed.
Install the Drain
(Royhan™ only)
•
• •
•
•
•
8) Confirm with Set-up
Diagram and install the
spout (Wall Mount only)