Totemacoustic.com
2)Volume:
When setting the volume control at the subwoofer, begin with your main speakers
playing at a normal listening level and the volume control of the subwoofer in MIN position. Then,
slowly turn up the volume until the desired bass level is achieved. Bass output will then be regulated
in conjunction with the speakers by your amplifier’s volume.
3)Frequency:
This control determines the frequencies the subwoofer will play. This frequency is
manually controlled and is continuously variable between 40-200Hz. Generally, Totem speakers are
set between 40 and 70 Hz for floor-standing speakers and 70Hz and above for Bookshelf speakers.
You can experiment with which position works best with your main speakers by turning this control
until the sound of the low frequency coming from the subwoofer is nicely blended with the sound of
your main speakers.
4)Phase:
Adjusts the phase of the Totem subwoofer to your main speakers. When in phase, the
system will produce a much fuller bass response. The simplest way to adjust the phase of your
system is to have a second individual to adjust the phase dial as you sit in the listening position.
9)Power Mode:
If the subwoofer is
being physically connected with an RCA wire
the subwoofer
should be set to the
LINE
setting. If the
Link
Wireless Transmitter
is being used in conjunction with
the subwoofer,
select the Wireless
(WL) setting. In the
ON
setting, the subwoofer
stays on and does
not go into standby
. The subwoofer is equipped with an automatic standby mode for the
Wired and
Wireless settings.
It activates approximately 20 minutes after not detecting a signal and wakes once a
signal is detected.
7)Inputs:
Left/Low frequency Effect, Right
When using a surround receiver or processor equipped with a single LFE or Subwoofer Output, use
the single LFE connection. If the component has both stereo Left and Right outputs, then connect to
both the Left and Right inputs.
See Connections for more explanations on setting up your
subwoofer.
10)AC Input and fuse holder:
Power cord connection. Fuse holder allows easy replacement of the
fuse as required. Be sure to replace it with a fuse of the same rating.
1)Main Power:
Turns the power ON or OFF
5)BASS EQ:
The Natural setting is pure and linear, providing tight, musical bass. High Impact
increases the output by several dB in the lower range of its frequencies, often preferred in home
theater and gaming.
6)PAIR:
The Tribe Solution SUB can be connected wirelessly in tandem with the Totem Link Wireless
Transmitter. Pushing the PAIR button on the Link and then on the sub will pair them. The red/green
LED indicates its status. Consult the LINK manual for wireless connection set up.
8)Status LED:
Red=Standby
Green=On
CONTROLS AND CONNECTIONS
Содержание TRIBE SOLUTION SUB
Страница 1: ...OWNERS MANUAL...
Страница 6: ...Totemacoustic com CONTROLS and CONNECTIONS CONTROLS AND CONNECTIONS...
