9
totemacoustic.com
alignment
Use the mounting template to place the locations for screw holes on the wall. The template is in 1:1 scale.
1 -
Make sure the vertical line A on the template is level.
2 -
Also make sure the horizontal line B is at least 4” (11 cm) from the ceiling.
3 -
Mark screw holes onto the wall as indicated on the template.
Note:
For a clean and trouble free installation, the speaker cable has to exit from the wall within the BOX.
fastening
wall
plate
to
wall
•
Wooden Stud: Drill four (4) 1/8” (0.32 cm) pilot holes 2½” (6.35 cm)deep and screw the wall plate to
the wall.
•
Brick or Block Wall: Drill four ¼” (0.635 cm) holes 1½” (3.81 cm) deep. Fit the plastic wall anchors and
screw the wall plates to the wall.
installing
speaker
onto
bracket
1.
Connect the cable to the terminals.
2.
Align vertical groove on the speaker back panel with wall bracket. Slowly lower the speaker and apply
pressure until it slides snugly into place.
3.
Once in place level the speaker.
