Totem T.R.U.C.K., Руководство пользователя

Страница: 40 / 44

1x 6-wire Totem Bus cable, black connectors, 15cm
Battery cable , fixed to the battery
Servo Cable , fixed to the servo motor
Connecting the TOTEM bus cable.
Connect the flat cable to one of the black connectors on
the X3 Base Board. In the picture, we have shown that the
Function Boards is temporarily removed. It’s much easier to
enter the cable when the Function Boards are removed.
FINAL STEP
Connecting the cables 1
X3
X2
X3
X2
The TOTEM bus cable is then connected to the X2 Base
Board. In the picture, the Function Board FB30 (power board)
is put back on. Arrange the flat cable under the boards, and
snap the connector into any of the 2 black connectors on the
X2 board. Don’t use force on these small connectors.
Connecting the Battery cable.
Connect the Battery cable to the BC1 (battery Connection
Board) with the XT60 connector. (yellow). The cable will
only fit the correct connector on the board, and cannot be
oriented wrong either.
Connecting the Servo Motor cable.
Connect the Servo as shown on the picture. It is important
that the
brown wire is facing towards the white connector
neighboring. If you plug in the wrong orientation, it will not
harm, but not work either.