2
WARNINGS AND CAUTIONS
– PUMP
WARNING
•
Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle (GFCI).
•
Do not exceed the voltage shown on the pump.
•
Always disconnect pump from the power source before beginning any maintenance or work on the
pump.
•
Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.
•
Do not remove the grounding pin from the power cord plug.
•
To reduce the risk of electric shock, use only on portable, self-contained fountains no larger than 5 ft. in
any dimension.
•
Risk of electrical shock – This pump has not been investigated for use in swimming pools or marine
areas.
CAUTION
•
This pump has been evaluated for use with water only.
•
Use a proper power source as indicated on the pump label.
•
Keep the cord away from high temperatures or other heat sources.
•
Do not pump heated liquids.
•
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
•
Operate in fresh water only. Avoid heavily chlorinated water and water with high pH levels.
•
Do not lift the pump by its power cord.
PREPARATION – LINER
Before installing your pond liner, make sure it is in good condition with no tears or holes. If you find any
damage, do not attempt to install the liner. Contact customer service for a replacement.
•
Estimated Assembly Time: 2 hours
•
Tools Required for Assembly: Sand, Shovel.
NOTES – LINER
Calculate the dimensions of your pond. Your pond should be at least 18 in. deep at the deepest point.
Allow for a 10 in. overlap around the perimeter of the pond. The 7 ft. x 10 ft. liner will create a pond that is
approximately 3 ft. x 6 ft. x 18 in. deep. It will hold approximately 200 gal. of water.
INSTALLATION INSTRUCTIONS – LINER
1. Use sand to mark the outline of your pond. Fig. 1
Fig. 1
