Programming
Occupied & Unoccupied Periods
Press
If Yes is selected:
Selecting Yes, then pressing MODE will copy the
previous day’s program and then will ask the
same copy question again. If yes is selected
each time, this routine will repeat until Saturday
is copied to Sunday. After Saturday is copied
to Sunday, the copy command is unavailable.
Off
On
Yes
No
MODE
Press
Press
If No is selected:
MODE
MODE
Occupied
Tu
1
Page 12
ON
We
Select Yes to copy the
previous day’s program
to the day displayed.
Select Occupied 1 to run
on this day (On), or not to
run on this day (Off).
If
No
is selected, as in previous steps, flashing prompts will appear to input start
and stop times for Occupied 1. If more than one occupied period was selected
in the first programming step (
page 9
), then the cool and heat setpoints, and
start and stop times for each additional occupied period will be prompted.
MODE
After programming for all seven days is complete, press
the MODE and UP buttons at the same time for two seconds
to leave the Setup screens. If no buttons are pressed, the
display will leave the setup screens after 30 seconds.
PROGRAMMING TIPS
If only the Occupied 1 period is selected in the first programming step (
page 9
), Occupied 2 & 3 programming steps
are skipped. Furthermore, if Occupied 2 is selected, Occupied 3 programming steps are skipped.
Heat & Cool setpoints for Occupied 1 are the same for every day of the week. If desired, Heat & Cool setpoints for
Occupied 2 & 3 can be adjusted differently for each day of the week.
If the start time is set later in the day than the stop time,
the program will run from the start time to midnight and
from midnight to the stop time on the same day.
For example: 9pm start, 8am stop, on Monday. In this example the
program will run from 12am Monday to 8am Monday and again from 9pm Monday to 12am Tuesday.
Unoccupied Operation:
The unoccupied settings take effect at all times when: (
1
) the program is on
and
(
2
) the
current time is outside a preset occupied period. For this reason start and stop times are not necessary for
unoccupied time periods.
If the
same
start and stop times are programmed for an occupied period, then it will run 24 hours.
If one occupied period starts and stops within another occupied period the lower occupied # has priority.
For example:
If Occupied 3 is programmed to be on 24 hours, and Occupied 2 is programmed to run that day, then the Occupied 2
setting will take over for Occupied 3 between Occupied 2 start and stop times.
