Total TTAC1601, Быстрый старт

Страница: 4 / 7

4
Start up
Mounting of accessories
Your inflator is supplied with the standard cone nozzles and the needle inflator nozzle,
which are located on the bottom of the unit. Remove the necessary accessories from the
accessory compartment.
•
To use the accessory you need, make sure the inflator lever is in
the up position as shown in the picture.
•
Place the adapter or accessory on the stem of the inflation needle
or the conical nozzle.
•
Push the quick coupler or inflator lever down to lock it in place.
• Attach the corresponding adapter to the item to be inflated:
LCD screen
Warning
Do not use the inflator when the car engine is running. Make sure your 12-volt accessory
outlet is live. On some vehicles, the accessory socket can only be activated when the
ignition key is in the accessory position.
To power the display with the 12 VdC adapter, simply plug the 12 VdC car charger (9)
into the vehicle's 12 V accessory socket.
Quick start
Do not leave the inflator running unattended. It can burst car tires and other items.
To use your inflator immediately, you can do so without setting the auto-off feature.
•
Before use, check the manufacturers recommended tire pressures for the vehicle
or item to be inflated.
• Plug the 12 VdC car charger (9) into the vehicle's accessory socket (cigarette
lighter). The LCD screen will turn on.
•
To switch between the different units (PSI, BAR or KPA) press the unit switch
button (6) until the required units are displayed.
• Attach the quick coupler (8) and an accessory, if needed, to the item to be
inflated, making sure the lever on the coupler is in the down position to lock into
place.
Note: Make sure the quick coupler is properly attached to the item to be inflated.
• To start the inflator, turn the main switch (1) to the on position.
•
When the item is inflated as needed or to stop the inflator at any time, press the
main switch (1) to the off position.
Auto shut-off pressure setting
Note: The LCD screen will only display inflation pressures when the inflator is in use.
•
Press and hold the - and + buttons (4 and 5) for 3 seconds, the value will increase
or decrease until the required value is obtained.
•
After 3 seconds the display will flash and return to a reading of "0.0". This is
normal.
•
Attach the quick coupler (8) and accessories (10, 11, 12), if necessary, to the
item to be inflated, making sure the quick coupler lever is in the down position to
lock it in place.
• To start the inflator, turn the main switch (1) to the on position.