Total TRHLI2201, Быстрый старт

Страница: 9 / 11

9
Temperature dependent overload protection.
When used as intended, the power tool cannot be subjected to overload. When the load
is too high or the permissible battery temperature of 75°C is exceeded, the electronic
control turns off the power tool until the temperature is back in the optimum temperature
range.
Deep discharge protection
The lithium-ion battery is protected against deep discharge by the "Discharge Protection
System". When the battery is empty, the machine is switched off by means of a protection
circuit: the inserted bit no longer rotates.
Work tips
If your power tool overheats, set the speed to maximum and let it run without load for 2-
3 minutes to cool down the motor. Quality, undamaged SDS plus drill bits should always
be used for concrete and masonry.
When drilling in metal, use only HSS drill bits in good condition. Whenever possible, use
a pilot hole before drilling a large diameter hole.
Troubleshooting and Maintenance
Maintenance and cleaning
Remove the battery pack from the tool before performing any adjustments, service, or
maintenance.
•
Your power tool requires no additional lubrication or maintenance.
• There are no user-serviceable parts in your power tool.
•
Keep the motor ventilation slots clean. Never use water or chemical cleaners to
clean your power tool. Clean with a dry towel.
•
Always store your power tool in a dry place.
• Keep all work controls free of dust.
•
You may occasionally see small sparks through the ventilation slots. This is
normal and will not damage your power tool.
Problem solving
Reasons for different charging times
Your charging time can be affected for many reasons other than defects in your product.
• If the battery pack is partially discharged, it can be recharged in less than 1 hour.
•
If the battery and ambient temperature are very low, recharging may take 1 to 1.5
hours.
•
If the battery pack is too hot, it will not recharge because the internal temperature
safety switch will prevent it.
•
If the battery pack is very hot, you should remove the battery pack from the
charger and let it cool down to room temperature first, then recharging can start.
•
If you charge a second battery immediately after the first, the charger may
overheat. Always allow at least 15 minutes of rest between charging the battery.
Reasons for different battery pack working times
Charging time problems or not using a battery for a long time will reduce the battery's
operating time. This can be corrected after several loading and unloading operations by
loading and working with your drill.