CUTTING WITH A NYLON HEAD
For nearly all cutting, it is good to tilt the
line head
so that contact is made on the part of the line
circle where the line is moving A W A Y from
you and the debris shield. (See appropriate)
This results in the debris being thrown A W
AY from you.
WARNIN
Ƹ
!
DANCER
The proper debris shield must be in place on the
unit when nylon cutting line is used, The cutting
line can flap around if too much line is exposed.
Always use the plastic debris shield with cut-off
knife when using nylon cutting heads.
WARNING
Ƹ
!
DANGER
Tilting the head to the wrong side will shoot the
debris TOWARDS you. If the line head is held flat
to the ground so that cutting occurs on the whole
line circle, debris will be THROWN at you, drag
will slow the engine down, and you will use up a
lot of line.
WARNING
Ƹ
!
DANGER
Use only quality nylon monofilament line of the
diameter 2.5mm, Never use wire or
wire-reinforced line in place of nylon trimmer
line. Load your nylon line cutting head only with
nylon trimmer line of the proper diameter.
WARNING
Ƹ
!
DANGER
Use extreme caution when operating over bare
spots and gravel, because the line can throw small
rock particles at high speeds. Debris shields on the
unit cannot stop objects which bounce or ricochet
off hard surfaces.
