Total TIDLI200215, Руководство пользователя, Страница: 14 / 16

14
Drilling operation
First, turn the adjusting screw so that the pointer points to the mark . Then proceed as
follows.
Drilling in wood
When drilling in wood, the best results are obtained with wood drills equipped with a
guide screw. The guide screw facilitates drilling by driving the bit into the workpiece.
Metal drilling
To prevent the bit from slipping when starting a hole, make a notch with a punch and
hammer at the point to be drilled. Place the tip of the drill bit in the notch and start drilling.
Use a cutting lubricant when drilling metal. The exceptions are iron and brass.
Attention
•
Excessive pressure on the tool will not speed up the drilling. In fact, this excessive
pressure will only serve to damage the tip of your bit, decrease tool performance,
and shorten tool life.
• Hold the tool firmly and be careful when the bit starts to break the workpiece.
Tremendous force is exerted on the tool/drill at the moment of hole breaking.
• A stuck bit can be removed by simply placing the reversing switch in reverse
rotation to back out. However, the tool can snap back if you do not hold it firmly.
• Always secure small workpieces in a vise or similar holding device.
• If the tool is used continuously until the battery cartridge is discharged, let the tool
rest for 15 minutes before continuing with a new battery.
Environment
•
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
•
Contact your local authority for information on available collection systems.
• If electrical appliances are disposed of in landfills, hazardous substances can
seep into the groundwater and enter the food chain, harming your health and
well-being.
•
Recycle raw materials instead of disposing of them as waste.
• The machine, accessories and packaging must be sorted for environmentally
friendly recycling.