Total TDLI200215, Руководство пользователя, Страница: 13 / 15

13
Drill in metal
To prevent the bit from slipping when starting a hole, make a dent with a center punch
and hammer at the point to be drilled. Place the tip of the drill bit into the notch and begin
drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass
which must be dry drilled.
Attention
•
Pressing the tool excessively will not speed up the drilling. In fact, this excessive
pressure will only serve to damage the tip of your bit, decrease tool performance,
and shorten tool life.
• Hold the tool firmly and be careful when the bit begins to break the workpiece. A
tremendous force is exerted on the tool / bit at the moment of hole breakage.
• A stuck bit can be removed simply by setting the reverse switch to reverse
rotation to reverse. However, the tool can back off abruptly if you do not hold it
firmly.
•
Always secure small workpieces in a vise or similar clamping device.
• If the tool is used continuously until the battery cartridge has discharged, allow
the tool to rest for 15 minutes before proceeding with a new battery.
Environment
• Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
• Contact your local authority for information on available collection systems.
•
If electrical appliances are disposed of in landfills, hazardous substances can
seep into groundwater and enter the food chain, damaging your health and well-
being.
• Recycle raw materials instead of disposing of them as waste.
•
The machine, accessories and packaging must be classified for environmentally
friendly recycling.