Total TCBNLI2001, Руководство пользователя

Страница: 11 / 17

11
Note: The nailer will not function properly if the selector is not properly set to the (T) or (TTT)
position. Always make sure the selector is seated properly to avoid unexpected discharge of nails
and possible serious personal injury.
•
Activate the tool in the following two ways. The tool is activated when the LED
work light is on.
1. Pull the trigger, and then remove your finger from it.
2. Reinstall the battery.
•
Keep a firm grip on the tool to maintain control. Place the tip of the tool on the
work surface.
•
Push the tool against the work surface to press the workpiece contact.
•
Pull the trigger to drive a nail.
• Push the tool against the work surface to press the workpiece contact and drive
a nail.
• Always remove the pliers from the trigger when you have driven the desired
number of nails.
Contact actuation mode
Contact actuation allows very fast and repetitive nailing.
• Slide the selector to the (TTT) position.
•
Activate the tool in the following two ways. The tool is activated when the LED
work light is on.
1. Squeeze the trigger, and then remove your finger from the trigger.
2. Reinstall the battery.
•
Keep a firm grip on the tool to maintain control.
• Pull and hold the trigger.
•
Push the tool against the work surface to press the workpiece contact and drive
a nail.
•
Always remove your finger from the trigger when the desired number of nails
have been driven.
Note: In contact actuation mode, the tool can also be operated by pressing the workpiece contact
against the surface and pulling the trigger.
LED work lights
There is an LED work light located on each side of the nailer. LED work light turns on
when trigger is pulled or battery is installed.
It is at full intensity in the first minute, then it goes dark and stays for 10 minutes until it
turns off.
Note: The tool is activated when the LED work light is on.
Low battery indicator
The headlights will flash four consecutive times and then turn off to indicate that the
battery is low.
D iagnostic information
LED work lights provide feedback to indicate if the battery pack is sufficiently charged
and/or if the tool is operating properly.
•
If the work lights are flashing, install a fully charged battery.
• If the light continues to blink, see the troubleshooting section for more
information.