Summer Shed Assembly
1. Pre Assembly
2. Side Panels & Front
3. Assemble Roofing
1a. Lay down the floor on a level and durable foundation to
take the weight of the shed and also keep a level ground to
build shed on. Use a spirit level to get exact results.
1b. Place any side panel to the edge of the flooring section
and then place the back section to fit perfectly in to the
edge of the side section. Drill the 2 sections together once in
place to make secure to each other. Do not drill to the floor
section just yet.
1c. Check that the 2 panels are level upright and horizontally
using a spirit level. Then place the 2nd side panel (See Pic 1c)
1d. Place side panels in
position and secure to the
side panels, again using
50mm screws provided.
Page 2 of 3
80mm S
cr
ew
s
80mm S
cr
ew
s
80mm S
cr
ew
s
50mm S
cr
ew
s
2a. When you have secured all of the
side panels to the back panel. Attach
the front door panel to the structure
a shown on diagram 2a.
2b. Secure using screws or nails
provided. Ensure the structure is
suitably secured at all 4 corners and
the panels are attached as shown.
PLEASE NOTE:
Drill driver is best
used for securing
panels with the
screws provided.
3. Secure Panels to Floor
3a. When you have secured all the panels together
now using the screws provided secure the panels to
the shed floor to finalies the main structure.
3b. Double check that all areas are straight and there
is no loose panels. It is important to make the
structure as stable as possible by screwing into the
sides and flooring.
PLEASE NOTE:
Drill driver is best
used for securing
panels with the
screws provided.
65mm Nails
1b
1c
2a
• Drill Driver
• Drill Driver
3a
• Drill Driver
= Screw and Secure
= Screw and Secure
3a
3b
40kg
Green Mineral Felt
• Hammer
• Stanley Knife
4a. Now apply the roof felt as
shown. Always apply at lowest
point first to ensure correct overlap
so rain water cannot run under the
felt and cause any damage.
3b. Tack down the roof felt to
structure and cut away any excess
felt that is overhanging.
PLEASE NOTE:
Neatly cut and tuck felt
under roof sides
Use hammer to
tack in felt to place
as shown in diagram along
white dotted lines.
• Drill Driver
3a. Once all the panels are secured in place then
attach the roof sections as shown in diagram 3a.
3b. Align the front and rear of the roof panels to
sit perfectly between the end panels as shown on
point 3b. The front lip of the roof should
overhang the top of front as shown on 3b.
PLEASE NOTE:
Drill driver is best
used for securing
panels with the
screws provided.
4. Apply Roof Felt
