www.totalsheds.co.uk
Attach Corner Strips
Now finish off the panels edges with the
corner strips provided.
SIDE STRIPS
(1174.75mm)
(45mm)
46.25” Length
1.77”
W
idth
x8
x2
DRILL
DRIVER
= Drill Points using
screws provided as shown
x16
4.0 x 38mm
STANLEY
KNIFE
Manual Page 10
APPLY ROOF FELT SHEETS x2
STEP • 15
STEP • 16
40kg Mineral Felt Roof
You will be provided with 2 lengths of roof felt.
Start with lower end of roof first.
HAMMER
TACKS PROVIDED
Proceed with 1st layer at the rear lowest point of
roof, then overlay the other sections in order as shown.
This method is to create rain flow towards rear of kennel.
After cutting away the excess felt, neatly fold over the edges and
secure each section down by tacking them to the kennel sides.
PROTECT YOUR KENNEL AGAINST THE RAIN & ELEMENTS.
Carefully check all the panels are fitted well and the kennel is
secure and stable.
You are almost done building your kennel!
1st
2nd
3rd
1st Sheet at rear of roof
2nd & 3rd Sheets above
Trim edges with 3” overhanging
Fold & tack edges neatly
A
B
C
D
© Sheds (Midlands) Limited 2021 • 12x4ft Dog Kennel
Now attached the corner/side strips to hide the corners and
joins between the panel sections as shown.
3962.4mm)
1m (1000mm)
(13ft) 156” Length
39”
W
idth
