Total Automotive Lifting Solutions Inc. TLSS14ALOFRR1, Инструкция по установке, эксплуатации и сервисному обслуживанию

Страница: 2 / 31

2
Your new lift will provide years of dependable service if installed, operated and maintained
properly.
Read and be prepared to follow all safety, installation,
operation, and maintenance instructions in this manual before
installing and operating the lift. In addition, read and follow all safety
and other information included on and with the lift be fore operating
the lift. Keep this manual in a secure place for future reference,
training and service part identification.
TABLE of CONTENTS
1. Unloading Procedure and Lift Package Contents page 3
2. Warranty and Safety page 4 - 6
3. General Requirements and Lift Specifications page 7 - 8
4. Pre Installation Procedures and Tools Required page 9 - 10
5. Installation Procedures page 10 - 12
6. Operating Instructions and Lift Maintenance page 13 - 14
7. Troubleshooting page 15
8. Lift Installation Diagrams and Parts Lists page 16 - 30
IMPORTANT :
It is the shop owner's responsibility to provide a satisfactory installation
area for the lift. Lifts should only be installed in a "pit" with a minimum of 4 inches (102mm)
/ 3000 psi (20.7MPa) concrete that has been aged a minimum of 30 days. Please consult a
qualified individual if any doubt exists concerning proper installation and subsequent safe
operation of the lift. Do not install the lift on asphalt or outdoors. (see "pit" detail – page 8)
Prior to installation, it is the shop owner's responsibility to provide constant electrical power
in the correct voltage, phase, etc., and all wiring for electrical hook-up of the lift. The shop
owner must insure that the electrical installation conforms to local building and safety codes.
Where required, the shop owner will provide an electrical isolation switch located in close
proximity to the lift. This switch will have an emergency stop capability and isolate electrical
power from the lift for servicing requirements.
Hydraulic oil cannot be shipped with the lift and will be supplied by either the shop owner or
the installer. ISO 32 hydraulic oil (10W non detergent hydraulic oil) must be used to fill the
reservoir tank before operating the lift. Grout for lift leveling must also be purchased locally.
It is the shop owner's responsibility to train all operators in
lift operation and lift safety.