P. 8
(1)Determine the installation locations of the
brackets so that the distance between the
brackets is the same as the width of the product
that you ordered. The direction of each Link
Bracket is shown below.
* The illustration applies to a ceiling attachment. In the
case of a wall attachment type, install the brackets
on the wall using the same procedure.
(2)Mount End Side Brackets with screws.
If you install the brackets while they are bent,
the screens are liable to move sluggishly or
drop off.
Installation and Detachment of a Link Type
One
Side
Operation
2 Units Link
3 Units Link
W2
W1
W2
W3
W1
* For right operation, install the brackets on the left
side as the part shown at right.
* For left operation, install the brackets on the right
side as the part shown at right.
<Right operation >
<Left operation>
Use fixing screws that are suitable for
the strength and the material of the wall
or window frame to which the brackets
are to be fixed.
Be sure to install each Side Holder
using at least two fixing screws.
Caution
W2
W1
P. 9
(3)Install the screen.
* The illustration applies to a ceiling-attachment type
(right operation).
Install the screen from the chain side.
Use the following sequence otherwise
you will be unable to install the screen.
Caution
2) Pull down the screen 5 to 10 cm, then set the
chain as the position of Chain Connector is
located on the rear side, then attach Chain
Connector is about 3 cm below Bottom Bar.
3)Insert the dowel (transparent) on the end of
the screen into Side Holder (right side).
* For left operation, insert the dowel into Side
Holder on the left side.
4) While holding the screen, insert Link Joint Pin
into Link Bracket, and then pass it through the
hole in the roll screen body side. Once you
have inserted Link Joint Pin to the rear, install
the cover while rotating it.
* After installing the cover, check to see if it has
been tightened securely.
1 ) Remove the cover of each Link Bracket
(other than Side Holders at both ends) on
the side opposite the chain.
Dowel
(transparent)
About 3cm
Chain
Connector
5-10cm
Link Bracket
Cover
Link Bracket
Link Joint Pin
Chain side
Bottom
Bar
