P. 6
P. 7
I−08090801
Bracket installation
Follow the illustrations for "Installation Method" on p.5 and use the included bracket
fixing screws to install the brackets.
<When the product width is 510mm or more>
Install the brackets within 50-80mm of the edges of the Head Rail.
If there are three brackets, be sure to install them at intervals that are as equally spaced as
possible.
Install so that the extended flange on the
Head Rail touches the back plate of the
brackets as shown in the illustration to
the right.
If installed incorrectly, the product may
fall.
After installing the main unit, make sure the main unit is secured to the brackets. If the
installing is insufficient, the bracket release button will be pressed in.
Caution
Installing the main unit
With the slats in the stacked position, latch
the temporary stopper hook onto the Head
Rail.
Push the Head Rail in until it clicks into place.
Installing the Valance
∗
If the optional
"Valance Joint Fixtures"
are specified, the Valance installing procedure will vary.
When removing the product from the brackets, be sure to support it with your hand.
Caution
Latch the protrusion on the lower portion of
the Head Rail onto the hook on the bottom of
the Valance Holder.
While holding in the button on the lower
portion of the Valance Holder, push in on the
Head Rail and latch the hook on the upper
portion of the Valance Holder onto the upper
portion of the Head Rail.
When the Valance is installed onto the Head Rail, do not move the Valance position.
Before adjusting the position, first remove the Valance and then re-mount.
Warning
Latch the protrusion on the lower portion of
the Head Rail onto the hook on the bottom of
the Valance Holder.
When using a Back Valance
Valance width
Product width (W)
According to the number of the ladder tapes,
the intervals are evently distributed.
Gear Box
Valance Holder
Valance Holder
Bracket
Valance
140
140
15
15
94
87
2
Latch onto the
temporary
stopper hook
Push in and up
Head Rail
Correct attachment
Incorrect attachment
Back plate of
the bracket
Extended flange
on the Head Rail
Pull forward
While pressing
the release
button
Head Rail
Uninstalling the main unit
With the slats in the stacked position, grasp
the main unit and pull the Head Rail forward
while pressing the bracket release button.
Remove the main unit from the temporary
stopper hook.
Latch the protrusion on the lower
portion of the release Head Rail
onto the hook on the bottom of
the Valance Holder.
Latch the hook on the upper portion of the Valance
Holder onto the upper portion of the Head Rail.
Hold in the button on the lower
portion of the Valance Holder
Head Rail
Head Rail
Attaching surface
Attaching surface
