4
TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive
IMPORTANT NOTE
Before you begin installing your CD-ROM, make sure your
computer is switched OFF and the power cable is disconnected.
CD-ROM JUMPER SETTINGS
In order for your CD-ROM to work properly, it may be necessary for
you to change the CD-ROM’s jumper settings.
Locate the block of jumpers on the back left side of the CD-ROM.
Jumper Location
Jumpers can be set in either an ON mode or OFF mode. If the jumper
covers both pins on the jumper block, it is ON, if there is no jumper or
only one of the pins is jumpered, the jumper is OFF. This section will
discuss the following jumper settings: SCSI ID, Parity, Eject, Test/
Audio Reproduction, Termination, and Power Supply.
SCSI-ID 0
no jumpers
on ID1, 2 or 4
POWER
TEST
PRV/ALW
TERM
ON/OFF
PRTY
ID4
ID2
ID1
Spare
Jumper
Plug
