Toshiba Rack Enclosure Installation Manual – 99881-000
6
8
Rack Enclosure Installation
The rack enclosure is extremely heavy. Do not attempt to unpack, move or install the enclosure
without assistance. Use two or more people to move the enclosure off the pallet. Do NOT push
on the center of the doors or side panels. Do NOT attempt to roll the enclosures sideways. Until
it has been properly installed and stabilized, the enclosure is prone to tipping and could cause
property damage and/or personal injury. Use a forklift or pallet jack to move the enclosure close
to its installation location with its original shipping container/packaging. Use the casters on the
enclosure for short distance only over smooth, stable surface; it is not intended to be used to roll
the enclosure over long distances.
Items Included with the rack enclosure (assembled):
User Guide/Manual
Keys (4 set)
Hardware Kit:
M6x16 mounting screws (40 qty.)
M6 cage nuts (40 qty.)
M6 plastic cup washers (40 qty.)
Tools Needed (not included):
T-25 Torx Screwdriver (adjusting mounting rail)
T-15 Torx Screwdriver (adjusting PDU/Cable Channel)
T-30 Torx Screwdriver (for door hinges when reversing door)
13-mm socket or wrench (removal of shipping bracket)
13-mm open end wrench (adjusting leveling feet)
8.1
Unpacking
WARNING: Use at least two people when unpacking and removing the enclosure from the
pallet.
1)
Ensure the rack enclosure is in upright and stable condition. Remove the plastic wrap by cutting along
the corner protectors to avoid scratching the enclosure.
2)
Remove the packaging material and discard as appropriate. Ensure to keep any packaging material
that you plan to reuse.
3)
Remove the shipping brackets that anchor the enclosure to the pallet. There are a total of 4 brackets (2
in the front and 2 in the rear/back). Use a 13-mm socket or wrench (not provided) to remove the bolts
from the bracket. Save the brackets for later use. The brackets can be attached to the enclosure and
floor to provide additional stability. Ensure the brackets are tightened until the brackets are flush to
the rack.
WARNING
