20
(E) 23HL85
Using the
remote contr
ol
To control a DVD player:
Program the remote control to recognize the brand of your DVD
player (see “Programming the remote control to operate your other
devices” below).
The buttons shown at right will then control the DVD player.
Press DVD first.
Programming the remote control to operate
your other devices
This remote control is pre-programmed to operate most Toshiba
satellite receivers, VCRs, and DVD players. To control a non-Toshiba
device (or a Toshiba device that the remote control is not pre-
programmed to operate), you must follow the steps below to program
your remote control.
1. Refer to the code tables (on pages 21 and 22) to find the
corresponding code for your device.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are programming the remote control to operate your:
• Cable TV converter/satellite receiver: Press CBL/SAT.
• VCR: Press VCR.
• DVD player: Press DVD.
3. While holding down DISPLAY, press the Channel Number
buttons to enter the three-digit code for your device within 10
seconds.
Note:
If you do not enter the code within 10 seconds from step 3, or if you
enter the wrong code, this operation is canceled.
4. Point the remote control at the cable TV converter/satellite
receiver, VCR or DVD player, and press POWER to test the
code.
• If the device responds, you entered the correct code.
• If the device does not respond, repeat steps 1–4 using
another code.
5. Press TV to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite receiver code ________________
VCR code ________________________________________
DVD player code
__________________________________
Note:
• When shipped from the factory, the remote control is set to operate
your TV.
• Each time you replace the batteries, you must reprogram the remote
control.
• Some newer VCRs are capable of working on either of two remote
codes. These VCRs have a switch labeled VCR1/VCR2.
If your VCR has this kind of switch and does not respond to any of
the codes for your VCR, set the switch to the other position (VCR1
or VCR2) and reprogram the remote control.
SKIP/
SEARCH
SKIP/
SEARCH
CLEAR
REC
TV/VCR
TOP MENU
REV
FF
PAUSE
PLAY
STOP
ENTER
EXIT
FAV
FAV
SLEEP
PIC SIZE
MENU/
ENTER
DVD MENU
CBL/SAT
DVD
TV
VCR
+10
CH RTN
INPUT
DISPLAY
MUTE
POWER
ENT
SKIP/
SEARCH
SKIP/
SEARCH
CLEAR
REC
TV/VCR
TOP MENU
REV
FF
PAUSE
PLAY
STOP
ENTER
EXIT
FAV
FAV
SLEEP
PIC SIZE
MENU/
ENTER
DVD MENU
CBL/SAT
DVD
TV
VCR
+10
CH RTN
INPUT
DISPLAY
MUTE
POWER
ENT
PIC SIZE
MUTE
POWER
DISPLAY
INPUT
Number
buttons
VOL+-
DVD
yzx
•
DVD MENU
ENTER
DVD controls
DVD SKIP/SEARCH
TOP MENU
CLEAR
DISPLAY
Channel
Numbers
TV
VCR
DVD
CBL/SAT
#01E17-22_23HL85
05.6.10, 3:15 PM
20
Black