Keypad Main Overview
Status LED
The logo LED located on the front panel of the TE3 Series Soft Starter will blink once every 10 seconds to
provide visual confirmation that all microprocessors in the soft starter are operating properly.
Setup by Individual Parameter Settings
Allows the user to change parameter settings one at a time. The individual parameters are grouped by
categories on the touchscreen.
From the Setup Wizard or Home menu, select the ‘Advanced’ menu. Set the required parameters from the
displayed menus. See Section 5.8 of the user manual for detailed descriptions of the available parameters.
Configuration from the Touchscreen
Use the on-screen buttons to enter data or to scroll through setup menus, using
the “Up,” Dn,” “BACK,” and
“NEXT” buttons as necessary. From the home “Menu” screen, select either “Auto Setup” or “Advanced.”
Status Screen
Supply Status
Turns RED if unit has
tripped on supply failure
Motor Overload Status
Turns RED if unit has
tripped on motor overload
Cooling Fan Status
Turns RED if unit has
tripped on fan failure
Temperature Status
Turns RED if unit has tripped
on over temperature
Motor Side Status
Turns RED if unit has
tripped on motor side
phase loss
Monitor
Displays overload percentage,
instantaneous running current
and power
Return to
previous
screen/menu
Enter Sub-Menus
Control
Start / Stop Motor only active when Local
control is enabled.
Home Menu Screen
Auto-Setup Menu
Logging Menus
Input/Output Menus
Advanced Menus
Device Menus
Monitor Screens
Return to
previous
screen/menu
Go to Status Menu
Control
Start / Stop Motor only active when Local
control is enabled.
California Customers:
California Proposition 65 Warning
WARNING: this product and associated accessories may contain chemicals known to the State of California to cause cancer, birt h defects, or other
reproductive harm. For more information visit https://p65warnings.ca.gov
TE3-A-QSL-092921
