Before installing the TE3 Series Low Voltage Digital Solid
State Soft Starter thoroughly read the user manual. To
download scan the QR Code to the right or visit
www.toshiba.com/tic
After all electrical connections have been made; apply power to the TE3 Series Soft Starter.
On initial power up, TE3 Series Soft Starter
will show a ‘Setup Wizard’ menu – Auto and Advanced. To jump
immediately to the pre-defined parameter sets, press the Auto button and follow the on-screen prompts to
select your application and set the motor Full Load Amps.
To automatically set up parameters on subsequent start-
up, select the ‘Home’ menu from the status screen
and select ‘Auto Setup’.
Setup Wizard
Control Wiring
– 110Vac
(Refer to user manual for 24Vdc Control)
2-Wire Control (110Vac)
3-Wire Control (110Vac)
L
N
DI1
DI1/2COM
DI2
DI3/4COM
DI3
DO5NO
DO5COM
FU1
EMERGENCY
STOP
120VAC
STOP
START
RESET
K1
N
(OPTIONAL)
LINE ISOLATION
CONTACTOR
(240V OPTIONAL)
OPTIONAL
L
N
DI1
DI1/2COM
DI2
DI3/4COM
DI3
DO5NO
DO5COM
FU1
EMERGENCY
STOP
120VAC
RUN
COMMAND
CONTACT
RESET
K1
N
(OPTIONAL)
LINE ISOLATION
CONTACTOR
(240V OPTIONAL)
OPTIONAL
