38
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message “The Lamp life is ending” When you see this
message, change the lamp.
Make sure the projector has been cooled down for at least
one hour before changing the lamp.
Warning:
Lamp
compartment is hot!
Allow it to cool down
before changing lamp!
Warning:
To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
1
3
4
2
Appendices (Continued)
Used Lamps
This projector’s lamps contain trace amounts of environmentally harmful inorganic mercury.
Be careful not to break used lamps, and dispose of them in accordance with local regulations.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the Power
button twice.
2. Allow the projector to cool down at least 1 hour.
3. Disconnect the power cord.
4. Use a screwdriver to remove the screw from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
8. Reset the lamp timer.
