Toshiba SureMark 4610 1NR, Руководство по оборудованию

Страница: 45 / 64

Chapter 4. Using and maintaining the 4610 printer
Using and maintaining the 4610 printer
This section contains information about the proper use and maintenance of the 4610 Model 1NR.
For detailed technical information, see Chapter 2, Product specifications on page 27.
Attention: All covers must be installed on the SureMark printer during operation.
Replenishing consumable supplies
You are responsible for replenishing consumable supplies, which include the paper rolls.
Make sure that you are using the recommended supplies for the 4610 printer, which are
described in the following sections.
Loading and replacing the paper roll
Ensure that you have the correct paper for the 4610. See “Supported thermal paper” on page
45.
1. Press and release the blue release button to release the paper door. In a wall-mount
configuration, you must also pull the door fully open, because of the brake feature that
decelerates it from the full force of gravity.
2. If necessary, remove any unused paper or the empty paper roll core before inserting a new
paper roll.
Note: Refer to the label inside the printer for a diagram of how to load paper.
3. Place the paper roll into the paper roll bucket as shown on the diagram. The leading edge of
the paper should come from the bottom of the roll as shown in the diagram.
Note: The thermal printhead will not print on paper with glue on it. If the new paper roll
was sealed by glue, tear off the 6 to 8 inches of paper with glue on it before loading it.
4. Close the paper cover.
5. Press the customer receipt feed button to advance the paper, to verify that the paper is
feeding correctly. Feed 30 cm (about 1 ft) of paper through to test for correct alignment.
Attention: Do not pull the receipt paper out of the printer with the paper access cover closed.
This disengages the paper feed. The paper feed motor must then catch up before the printer can
feed the paper, which causes missing lines or partial lines of print. Use the customer receipt feed
button to advance the receipt and all lines will print.
Supported thermal paper
Attention: Using an inferior grade of paper can affect print quality as well as the life of
printheads and the printer mechanism.
Note: When selecting a paper, ensure that the paper's archive life meets the requirements of the
tax authorities of your country for archiving tax-related data.
The paper used in the thermal receipt station must meet the following requirements:
Width
79.5 ± 0.5 mm (3.13 ± 0.02 in.) or 57.5 ± 0.5 mm (2.26 ± 0.02 in.)
Outside Diameter
102 mm (4.0 in.) maximum
Thickness
60 μm (0.00225 in.) optimal. Range: 41 μm minimum to 99 μm maximum.
© Copyright Toshiba Global Commerce Solutions, Inc. 2017
45