Toshiba Strata, Руководство по установке

Страница: 19 / 28

Installation
MAS Recovery
Strata CIX Media Application Server Installation 07/06
13
Step 4F: Set MAS Static IP Address
This procedure is used to change the MAS static IP Address from the default setting. The MAS must
be mounted in the rack, the power cord plugged in and the IP cable installed between the MAS and
the IP switch (LAN).
Note This procedure requires a monitor, keyboard and mouse connected directly to the MAS.
Refer to
“MAS Connection Block Diagram” on page 1 .
1. At the MAS console select Start > Control > Panel > Network and Internet connection. Click on
Network Connection.
2. Right click on Local Area Connection for Intel® PRO/1000 CT Network. Then select
Properties.
3. Highlight Internet Protocol (TCP/IP) then click on the Properties button.
4. Select “Use the following IP address,” then enter the following:
• IP Address:
• Subnet Mask:
• Default Gateway: <BLANK>
5. Click OK.
Step 4G: SES Voice Mail and ACD Setup
When the MAS reboots log in to eManager. Refer to the Programming Manual Volume One for
setting up user accounts. Then program the CIX for SES and ACD applications as appropriate.
MAS Recovery
In the event that MAS suffers a catastrophic failure the following procedures will restore the MAS
to the configuration it was in when shipped. If possible backup the data, configuration and license
files before starting. At the conclusion of these steps return to the MAS Software Setup section of
this chapter.
Important!
The MAS Recovery procedure MUST be followed completely. Do not stop until the
procedure is complete.
Step 1A: Restore Using the Recovery CD Set
1. Ensure that the LAN cable from the 1Gbps connector on the MAS is NOT connected. Refer to
Figure 3 on Page 2 .
Important!
Ensure that the MAS does NOT have internet access at this time.
2. Connect power cable to your MAS server and power up the server.
3. Power up the MAS by setting the AC Input Switch to on, then depress and release the Power
Switch on the rear panel switch. Refer to
Figure 4 on Page 3 .
4. Insert the Recovery CD number one into the CD-ROM Drive.
(Note: DO NOT remove this CD until instructed to insert another CD-ROM.)
5. Restart the MAS by pressing the Reset Button the rear panel. Refer to Figure 4 on page 3 .
The computer will boot from the CD into the recovery environment.
Note Until the recovery is complete the mouse will not function.