Toshiba Strata AirLink DK40i, Руководство по установке и обслуживанию

Страница: 470 / 724

Station Apparatus
DKT2001 Digital Single Line Telephone
11-20
Strata DK I&M 6/00
6. Position the HHEU PCB on the standoffs inside the base, and secure with the two provided
screws.
Note
See Figures 11-15 ~ 11-17 for Steps 7 ~ 8 .
7. For 2000-series digital telephones. Connect the wire plug of the HHEU PCB to the HHEU
connector on the PCB in the phone.
...or for 1000-series digital telephones. Connect the wire plug of the HHEU to the HHEU
connector on the PCB of the phone.
8. For 2000-series digital telephones: If an HESB will be connected to the HHEU (for Loud
Ringing Bell), locate the EX.SP strap on the PCB in the telephone and cut the strap.
...or for 1000-series digital telephones: If an HESB will be connected to the HHEU, locate and
cut the EX.SP strap on the upper PCB in the phone.
9. For 2000-series digital telephones: If a headset will be connected to the HHEU, locate and cut
the HHEU strap on the PCB in the phone.
...or for 1000-series digital telephones: a headset will be connected to the HHEU, locate and
cut the HHEU strap on the upper PCB in the phone
Note
If the HHEU PCB is removed from the phone, the HHEU strap must be replaced for
proper telephone operation.
10. Reinstall the telephone base; secure with the four captive screws.
➤
To adjust the volume of the HESB Loud Ringing Bell
1. Call the telephone connected to the HESB.
2. Adjust the volume control on the back of the HESB and the ring volume control on the
telephone.
Carbon Headset/Handset Straps
If a carbon-type handset or headset is connected to the handset jack on the side of the telephone,
two jumper straps inside the telephone must be cut.
➤
To cut the straps
Note
You do not need to cut these straps if the headset is connected to the HHEU.
See Figures 11-7 and 11-15 ~ 11-17 and follow these steps:
1. Loosen the four captive screws on the telephone base, and remove the base.
2. For 2000-series digital telephones, and cut the W201 and W202 carbon straps.
...or
For 1000-series digital telephones, cut the carbon straps (W301 and W302 on the DKT1020-
SD; W201 and W203 on the DKT1020-H).
3. Reinstall the telephone base, and secure it with its four captive screws.