175
Expansion Options
Using an external monitor
❖
A video display device, such as a video projection unit, via the
television jack.
❖
An external SVGA monitor via the video-out port.
Before connecting your television, video projector, monitor or
other display device, configure your computer for the type of
device you’re connecting. To do this, refer to your operating
system documentation.
Connecting the display device
If you’re connecting a television or other video display device to
the computer’s television jack, refer to the following section for
guidelines on choosing a video cable, then refer to
device to the television jack” on page 175
If you’re connecting an SVGA monitor, skip to
Selecting video cables
To connect a device to the television jack, you need a video cable
(not included with your system). For the best video quality, always
use a properly shielded cable.
HINT: Toshiba recommends using a cable no longer than
20 feet (approximately 6 meters).
Using a poor quality cable may result in a dull or fuzzy picture,
poor color, ghosting, video noise, or loss of video.
Connecting a device to the television jack
1
Connect one end of the video cable to the external video
device.
Содержание SpectraLink 6000 System
