26
P
repar
ations
Preparation of the remote control
Insert the specified battery to the remote control. See
page
7
for safe use of coin-shaped batteries.
1
Gently insert a fingernail in groove 1
and pull out the holder in direction 2 .
Take care not to break your fingernail.
2
Place a coin-shaped
battery (CR2025) with the
side up on the holder.
Keep the holder horizontal so that
the battery does not fall through.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
3
Insert the holder into the remote control.
The remote control battery contains Perchlorate
Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Operating with the remote control
Point the remote control at the remote sensor and press
the buttons.
Distance: About 9.9 feet (3 m) from the front of the remote
sensor
Angle: About 30° in each direction of the front of the
remote sensor
Do not expose the remote sensor of the player to a strong light
source such as direct sunlight or other illumination. If you do so,
you may not be able to operate the player via the remote control.
•
Do not drop or give the remote control a shock.
•
Do not leave the remote control near an extremely hot or humid place.
•
Do not spill water or put anything wet on the remote control.
•
Do not disassemble the remote control.
•
If the remote control does not function correctly or if the operating
range becomes reduced, replace the battery with new one.
•
Inserting a battery other than the specified one or an object may
damage the remote control.
5
2
0
2
R
C
V
3
Backside
1
2
Within about 9.9 feet (3 m)
SDP74SWN̲E̲02-52.indd 26
SDP74SWN̲E̲02-52.indd 26
2010/02/03 11:11:26
2010/02/03 11:11:26