(2) LCD cable Holder (change2)
In SD-P2600, the LCD cable is fixed with the LCD Cable Holder instead of the insulator in SD-
P2500. The following explains how to disassemble and reassemble the LCD Cable Holder.
M2x5.0
LCD Cable Holder
-Disassembling procedure
a) Remove the two screws securing the LCD Cable Holder.
b) Remove the LCD Cable Holder.
-Reassembling procedure
a) Install the LCD Cable Holder to the LCD assembly.
b) Secure the LCD Cable Holder with the two screws.
(3) Power supply harness (change3)
To remove the Power IF board from the system board, unsolder the circled portion and
disconnect the cable.
When soldering, make sure
that the Power supply harness
is soldered fully.
And also pay attention to its
order as shown in the picture.
