Toshiba SD-34VLSL, Руководство пользователя

Страница: 13 / 48

1-18
Tips:
• Depending on your TV and other equipment you wish to
connect, there are various ways you could connect the
unit.
• Please refer to the manuals of your TV, Stereo System or
other devices as necessary to make the best connections.
• For better sound reproduction, connect this unit’s AUDIO
OUT jacks to the audio in jacks of your amplifier, receiver,
stereo or audio/video equipment. See “Connecting to
Optional Equipment” on page 14.
Caution:
• This DVD+VCR only support PAL system (refer to VCR
part only).
• Make sure this unit is connected directly to the TV. Set the
TV to the correct video input channel.
• Do not connect this unit’s AUDIO OUT jack to the phono
in jack (record deck) of your audio system.
Connecting to a TV and
Decoder (or Set Top Box)
•
Make one of the following connections, depending
on the capabilities of your existing equipment.
•
RGB signal is only exclusive for DVD playback.
Basic connection (AV)
1. Connect the EURO AV1 AUDIO/VIDEO on the
rear panel of this unit to the SCART input socket
on the TV using a SCART lead (not supplied).
For TV without SCART, connect the yellow VIDEO
OUT jack and DVD/VCR AUDIO OUT jacks of this
unit to the TV.
2. Some TV broadcasters transmit encoded televi-
sion signals which you can only see with a pur-
chased or rented decoder. You can connect such
a decoder (descrambler) to this unit.
Basic connection (RF)
1. Connect the RF antenna cable from your indoor/
outdoor antenna to AERIAL jack on the rear
panel of this unit.
2. Connect the supplied RF antenna cable from the
RF.OUT (DVD/VCR OUT) jack on the rear panel
of this unit to your television’s Antenna Input.
S-Video connection
1. Connect the S-VIDEO OUT jack on this unit to the
S-Video in jack on the TV using the S-Video cable
(not supplied).
2. Connect the Left and Right AUDIO OUT (DVD
EXCLUSIVE OUT) jacks of this unit to the audio
left/right in jacks on the TV using the audio
cables.
Component (Color Stream
®
) / Progressive
Scan (ColorStream ® pro) Video connection
(DVD EXCLUSIVE OUT)
1. Connect the COMPONENT/PROGRESSIVE
SCAN VIDEO OUT (DVD EXCLUSIVE OUT)
jacks on the DVD+VCR to the corresponding in
jacks on the TV using an Y Pb Pr cable (not sup-
plied).
2. Connect the Left and Right AUDIO OUT (DVD
EXCLUSIVE OUT) jacks of the DVD+VCR to the
audio left/right in jacks on the TV using the audio
cables.
Notes:
• If your television is a high-definition or “digital ready” tele-
vision, you may take advantage of the DVD+VCR’s pro-
gressive scan output for the highest video resolution pos-
sible.
• Set the Progressive Scan to “On” on the setup menu for
progressive scan signal, see page 22.
• When you use Component Video signal (interlace mode),
set the Progressive Scan to “Off” on the setup menu.
• If you set Progressive Scan to ON in error, you must reset
the DVD+VCR. First, remove the disc in the DVD+VCR.
Next, press STOP (
■
) and hold it for five seconds before
releasing it. The video output will be restored to the stan-
dard setting, and a picture will once again be visible on a
conventional analog TV or monitor.
• If the TV has an S-video input, connect the DVD+VCR
with the S-video cable. When using an S-video cable, do
not connect the yellow video cable.
Preparation
Intr
oduction