Toshiba SD-1300A, Руководство по обслуживанию

Страница: 47 / 93

2-7
Screws (1)
Washars (2)
Damper
(Black)
Damper
(Blue)
Damper
(Blue)
Damper
(Black)
Pickup mechanism
assembly (3)
1-3-4. Sub Chassis (with a pickup mechanism)
1. Turn the mechanism chassis assembly (1) upside down.
2. Remove one screw (2) and one washer (3) release the
boss “A” from the claw. Then remove the sub chassis (4)
(with the pickup mechanism) by sliding in the arrow
direction.
3. When mounting, perform the reverse order of the
removal.
Note:
• When mounting the sub chassis (4) (with the pickup
mechanism), first, insert the boss “C” along the groove
of the cam slider up/down cam (5) and next, the boss
“B” and “A”.
• The boss “A” may be used with washers. (One or two
washers are used to prevent from the slust rattling. In
some cases, no washer is used.)
When the washer(s) is used, be sure to assemble as it
was without losing.
Fig. 2-1-15
Screw (2)
Boss A
Washer
Washer (3)
Sub chassis (4)
(with the pickup mechanism attached)
Boss C
Boss B
Cam slider
up/down cam (5)
Groove
Claw
Groove
Mechanism chassis
assembly (1)
Boss A
Claw
Boss B
Groove
1-3-5. Pickup Mechanism Assembly
<Removal>
1. Remove four screws (1) and four washers (2) then
remove the pickup mechanism assembly (3).
<Mounting>
1. Replace the pickup mechanism assembly (3) with a
new one.
2. When mounting, perform the reverse order of the
removal.
Fig. 2-1-16
Note:
• The dampers’ color differs when used for the front
side and the rear.
• When mounting the pickup mechanism assembly (2)
with the screws (1), push the pickup mechanism assem-
bly (2) downward without being caught and tighten the
screws (1) after placing the washer with the damper bent.
Fig. 2-1-17
Damper
Screw (1)
Washer (2)
Pickup mechanism
assembly (2)