Toshiba RS-TX60, Руководство для пользователя

Страница: 25 / 204

17
S e t u p 4 : C a b l e B o x a n d S a t e l l i t e B o x
1
Make sure the cables from the wall are connected to your cable and satellite boxes.
Connect a Composite A/V cable from the
Audio/Video Output
jacks on the satellite
box to the
Audio/Video Input 1
jacks on the back of the DMS.
Connect a Coaxial RF cable from the
RF Out
jack on the cable box to the
Cable/Antenna-RF In
jack on the DMS.
Connect a Composite A/V cable from the
Audio/Video Output
jacks on the DMS to
the
Audio/Video Input
jacks on your TV.
Connect the phone cord (see page 8). After you complete Guided Setup, you can
connect your DMS to a home network and use a broadband Internet connection instead
of a phone line to connect to the TiVo service. See Chapter 8.
Channel changing cables:
First, see page 5 to check
whether you can use the Serial Control cable for either your
satellite or cable box. If you can, connect it as shown in the
diagram to the right. Then use the IR Control cable for the
other box. If you can’t use the Serial Control cable for
either box, you can use the IR control cable for both. See
the IR diagrams at the right.
Plug in all power cords and turn on your TV.
Set your TV to display video from the input jacks you used in step . You may have
to find the correct TV input setting by pressing the Input or TV/Video button on your
TV’s remote control until you see the Welcome screen. (For more help, see page 131.)
Once you see the Welcome screen, you’re ready to complete Guided Setup. If you need
help, see Chapter 2.
Connect Channel Changing Cables
IR Control cable for one box:
(a) Plug the purple end of the IR Control cable into
the Control Out-IR connector (the lower mini-jack)
on the DMS.
(b) Locate the IR sensor (see page 6 for
help).
(c)
Mount the IR emitters. Place one emitter
on top of the cable/satellite box and the other
underneath it. Be sure both emitters stick out about
1.5 inches directly in front of the IR sensor. Use the
provided adhesive strips to hold the emitters in place.
IR Control cable for both boxes:
Follow steps (a) and (b) as above. In step (c) ,
mount the IR emitters on top of each box as shown.
Cable Box
Satellite Box
b
a
c
b
c
IR Control for Cable and Satellite
®
Digital Media
Server
Cable or
Satellite Box
b
c
a
IR Control cable connection
®
Digital Media
Server
Serial
Serial Control
cable connection