Toshiba XXXXXXX(
X
/X)
– 34 –
4-way Air Discharge Cassette Type
Owner’s Manual
EN
4
CORRECT USAGE
• When you use the air conditioner for the first time or when you change the setting, follow the steps below.
Settings are saved in memory and are displayed anytime the unit is turned on by pushing the
button.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but
it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
button without turning off the main power switch
and the leakage breaker.
• When you re-power the air conditioner after it has not been used for a long period, turn on the leakage breaker
at least 12 hours before starting the air conditioner. (This is required to turn on the compressor case heater for
warming in order to prevent overload on the compressor when activating the outdoor unit.)
Start
1
Push
button.
The operation lamp illuminates, and the operation
starts.
2
Select an operation mode with the “
”
button.
One push of the button, and the display changes
in the order shown below.
3
Select fan speed with “
” button.
One push of the button, and the display changes
in the order shown as follows.
• When fan is in “
auto”, fan speed is
adjusted based on difference between set point
and room temperature.
• In heating operation, if the room temperature is
not heated sufficiently with volume “
low”
operation, select “
medium” or “
high”
operation.
• The temperature sensor detects the return air
temperature at the indoor unit, which differs
from the room temperature depending on the
installation condition.
Set point is a target of room temperature.
(
“auto” is not selectable in the fan mode.)
4
Select a desired set point by pushing the
“TEMP. ”
or
“TEMP. ”
buttons.
Stop
Push
button.
The operation lamp goes off, and the operation stops.
In the cool, dry, or auto (cooling) mode, the fan runs for
10 minutes (or more) for self cleaning.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
1
3
2
4
Auto
Heat
Dry
Cool
Fan
Low
Medium
High
Auto
9-EN
+00EH99928701_01EN.book Page 34 Monday, May 17, 2010 6:10 PM
