– 4 –
EN
ID
ID
instructions. Also wear a helmet for use in industry as protective
gear to undertake the work.
• When cleaning the
fi
lter or other parts of the outdoor unit, set
the circuit breaker to OFF without fail, and place a “Work in
progress” sign near the circuit breaker before proceeding with
the work.
• When working at heights, put a sign in place so that no-one will
approach the work location, before proceeding with the work.
Parts and other objects may fall from above, possibly injuring a
person below.
• You shall ensure that the air conditioner is transported in stable
condition. If any part of the product is broken, contact the
dealer.
• Do not modify the products. Do not also disassemble or modify
the parts. It may cause a
fi
re, electric shock or injury.
• This appliance is intended to be used by expert or trained users
in shops, in light industry, or for commercial use by lay persons.
About the refrigerant
• This product contains
fl
uorinated greenhouse gases.
• Do not vent gases to the atmosphere.
• The appliance shall be stored in a room without continuously
operating ignition sources (for example: open
fl
ames, an
operating gas appliance or an operating electric heater).
• Do not pierce or burn refrigerant cycle parts.
• Do not use means to accelerate the defrosting process or to
clean, other than those recommended by the manufacturer.
• Be aware that refrigerants may not contain an odour.
• The refrigerant inside the unit is
fl
ammable. If the refrigerant
leaks in the room and comes in contact with
fi
re from a burner,
a heater, or a cooker, it may result in
fi
re or the formation of a
harmful gas.
• Turn off any combustible heating devices, ventilate the room,
and contact the dealer from which you purchased the unit.
• Do not use the unit until a service person con
fi
rms that the
portion from which the refrigerant leaked is repaired.
• When installing, relocating, or servicing the air conditioner, use
only the speci
fi
ed refrigerant (R32) to charge the refrigerant
lines. Do not mix it with any other refrigerant and do not allow
air to remain in the lines.
1
Precautions for safety
The manufacturer shall not assume any liability for the damage
caused by not observing the description of this manual.
WARNING
General
• Before starting to install the air conditioner, read carefully
through the Installation Manual, and follow its instructions to
install the air conditioner.
• Only a quali
fi
ed installer(*1) or quali
fi
ed service person(*1) is
allowed to install the air conditioner. If the air conditioner is
installed by an unquali
fi
ed individual, a
fi
re, electric shocks,
injury, water leakage, noise and/or vibration may result.
• Do not use any refrigerant different from the one speci
fi
ed for
complement or replacement. Otherwise, abnormally high
pressure may be generated in the refrigeration cycle, which
may result in a failure or explosion of the product or an injury to
your body.
• When transporting the air conditioner, use a forklift and when
move the air conditioner by hand with 4 peoples.
• Before carrying out the installation, maintenance, repair or
remove work, be sure to set the circuit breaker to the OFF
position and being performed under Lockout/Tag out.
• Only a quali
fi
ed installer(*1) or quali
fi
ed service person(*1) is
allowed to undertake work at heights using a stand of 50 cm or
more.
• Wear protective gloves and safety work clothing during
installation, servicing and removal.
• Do not touch the aluminum
fi
n of the outdoor unit. You may
injure yourself if you do so. If the
fi
n must be touched for some
reason,
fi
rst put on protective gloves and safety work clothing,
and then proceed.
• Do not climb onto or place objects on top of the outdoor unit.
You may fall or the objects may fall off of the outdoor unit and
result in injury.
• When working at heights, use a ladder which complies with the
ISO 14122 standard, and follow the procedure in the ladder’s
7-EN
8-EN
