Toshiba RAS-300ASG, Инструкция для владельца и по установке

Страница: 6 / 35

4 5
BEFORE OPERATION
EMER .
butto n
Indoor Unit Display
Emergency Operation
Test Operation
①
Blue light : normally off.
②
Orange light : illuminated during timer mode.
③
Green light : illuminated during operation.
④
EMER. button
When the remote control is lost, damaged or the bettery is discharged, the EMER. button can be used to run the unit.
• Press the EMER. button once briefly at the off mode condition, shorter than for 5 sec.
- According to the room temperature, the unit operates the Cool mode in cool only model and the Auto mode in Heat pump model.
• If you want to stop the emergency operation, push the EMER. button again or operate the remote control.
• The setting conditions of emergency operation are as follows:
• EMER. button :
Can be used when the remote
control is lost or inoperative.
This operation is used for checking after unit installation.
• Press the EMER. button continuously during 5~10sec. And then unit will be operated
as test mode.
• Press the EMER. button once more after checking to activate the remote control. If
there is any input signal (remote control signal or EMER. button press) during test
operation, the TEST mode will change to the input signal mode.
• The setting conditions of the test operation are as follows:
- Operation mode : COOL - Fan speed : HIGH
- Timer mode : Disable - Discharge air direction : SWING
Model Operation Preset mode Fan speed
Timer mode
temperature
Discharge air direction
Cooling only COOL 24
℃
AUTO Disable Horizontal
Heat Pump AUTO 25
℃
AUTO Disable
Preset location according
to 'Cool' or 'Heat' mode