Toshiba RAS-18N3ACV Series, Руководство по обслуживанию

Страница: 44 / 97

– 43 –
10. INSTALLATION PROCEDURE
10-1. Installation Diagram of Indoor and Outdoor Units
FILE NO. SVM-12053
Before installing the wireless remote controller
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and ( − ) positions.
3 Batteries
2 Wireless remote controller
Shield pipe
Air filter
Hook
Hook
170 m
m or m
ore
50
m
m
o
r
m
or
e
170 m
m or m
ore
1
Installation
plate
For the rear left and left piping
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Make sure to run the drain hose
sloped downward.
Cut the piping
hole sloped
slightly.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Left
Bottom right
Rear
left
Bottom left
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam
8
Flat head
wood screw
3 Batteries
2
Wireless remote control
4
Remote control holder
6
Filter
5
Filter
8
Flat head
wood screw
9
Flat head wood screw
10 Battery cover
(A)
(B)
(C)
(D)
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension
drain hose
(Not available,
provided by installer)
100
mm
or
mo
re
100 m
m or
more
600
mm
or
mo
re
600 m
m or
more
60
0
m
m
o
r
m
or
e
The provided Remote Controller is a
wireless type, which also can be used
as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
When installing the outdoor unit,
leave open in at least two of direction
(A), (B), (C) and (D) shown in the
fi gure on the right.
Remark :
•
Detail of accessory and installation
parts can see in the accessory sheet.
•
Some pictures might be different from
the actual parts.
Wall