37
Special points to consider
In case the remote control is misplaced, temporary Automatic operation is available from Temporary switch on the indoor unit.
If the remote control is not available
In the event 2 air conditioners are installed in close proximity
■
When operating
■
To stop
•
Fully Automatic operation. (Temperature and air
volume are set automatically).
•
Operation lamp turns on.
A - B Selection
To separate remote control usage for each indoor unit in case 2 air conditioners are installed adjacent to each other.
※
Indoor unit and remote control are set to A when shipped from the factory.
•
Automatic cleaning is not operated.
•
Operation lamp turns off.
B setting
How to set both the indoor unit and the remote control to B
1
Press Temporary switch for approx. 1 second to start automatic operation.
2
Press and hold
CHECK
then press
on the remote control. It will show B on the display
and send a signal to the indoor unit.
Make sure that the Indoor unit can receive signal of the remote control while doing this step.
3
Check that the remote control can operate the indoor unit.
•
Cooling or Heating starts after 10 seconds with a “Pi” sound. However, continue to press it.
Setting completes when the “Pi” sounds 5 times and the operation lamp blinks.
•
To cancel it, repeat the above operation (in this case, the operation lamp does not blink)
Start the operation smoothly and reduce the operating noise.
Concern about the operating noise
Press for 20 seconds
Quiet
When setting is complete.
Pi P
i Pi Pi
Pi
1 second
1 second
again
1 second
20 seconds
