10
EN
TOSHIBA RAS-07/10/13UKP (US) 1075000802
TIMER OPERATION
ON timer and OFF timer
Setting TIMER
1
1
1
1
1
ON/OFF TIMER button
Press the ON or OFF TIMER buttons as required.
•
The previous timer setting is displayed and flashes along
with ON/OFF TIMER display.
2
2
2
2
2
TIMER button
Press the TIMER button.
Set the timer to the desired time.
Each press of the TIMER button changes the time in ten minute steps.
Pressing the TIMER button continually changes the time in one hour steps.
3
3
3
3
3
SET
SET
button
Press the SET
SET
button to set the timer.
The timer time is indicated and the timer starts.
4
4
4
4
4
CLR
CLR
button
Press the CLR
CLR
button to cancel the timer setting.
Once you select the timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions when you simply press the ON/OFF
button of the remote control.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section “SETTING THE CLOCK” on page 6 to set the clock, and then set the timer.
CAUTION
•
When you select the timer operation, the remote control
automatically transmits the timer signal to the indoor unit at the
specified time. Therefore, keep the remote control in a location
where it can transmit the signal to the indoor unit properly.
•
If you do not press the SET
SET
button within 30 seconds after
setting the time, the setting will be cancelled.
Hi POWER OPERATION
High power (Hi POWER)
•
The Hi POWER (high power operation) mode automatically controls room
temperature, air flow and operation mode so that the room is quickly
cooled in summer. (
see page 15.)
Setting Hi POWER mode
1
1
1
1
1
Hi POWER button
Press the Hi POWER button. The Hi POWER lamp (green) on the display
panel of the indoor unit lights up. At the same time, the “Hi POWER” mark
on the remote control is indicated.
Canceling Hi POWER mode
1
1
1
1
1
Hi POWER button
Press the Hi POWER button once again.
The Hi POWER lamp on the display panel of the indoor unit lights goes out.
At the same time, the “Hi POWER” mark on the remote control goes out.
CAUTION
The Hi POWER mode cannot be activated in the DRY and FAN ONLY
operation and when the ON TIMER operation is reserved.
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
1
1
A
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
4
2
3
1
4
2
3
1
01RAS-07/10/13UKP P09-12
2/1/02, 12:02 AM
10
Содержание RAS-07UA-E
Страница 7: ...MEMO ...